Splicer Bank - Wiring
This page describes the wiring of three splicers combined together that are wired to distribute power from the battery to the ROVERHAT-PCB.
Combine three 1 in 2 out splicers.
Add the 3-inch black jumper wire between the first 2 splicers on the ends with 2 terminals.
Connect a Black - 4.8mm female spade crimp terminal wire to the singular terminal on the first splicer.
Connect the female spade end of the Black - 4.8mm female spade crimp terminal wire to the negative terminal of the battery.
Connect the black wire from the Power Plug on the Interface Lip assembly to the singular terminal of the second splicer.
Connect a Red - 4.8mm female spade crimp terminal wire to the singular port on the third splicer.
Connect the female spade end of the Red - 4.8mm female spade crimp terminal wire to the terminal on the rocker switch under the “||” symbol.
Connect a 12-inch black jumper wire from the first terminal on the first splicer on the side with two terminals.
Connect a 12-inch red jumper wire from the first terminal on the third splicer on the side with two terminals.
Route the red and black 12-inch jumper wires through the battery bracket pocket holder then through the wire trap on the ROVERHAT-PCB riser tray. Insert the red wire into the positive port on the terminal block and the black wire into the negative port on the terminal block of the ROVERHAT-PCB.
Last updated