Power Plug - Wiring

This page describes wiring the power plug.

Completed power plug wiring.

  1. Connect the red wire from the power plug on the Interface Lip assembly to one of the ends of a 1 in 1 out splicer.

Red wire from power plug connected to one side of the 1 in 1 out splicer.

  1. Connect a Red - 4.8mm female spade crimp terminal wire to the other end of the 1 in 1 out splicer.

Red - 4.8mm female spade crimp terminal wire connected to other end of splicer.

  1. Connect the female spade end of the Red - 4.8mm female spade crimp terminal wire to the terminal of the Rocker Switch under the “|” position.

Red-4.8mm female spade crimp terminal wire connected to "|" terminal on rocker switch.
PreviousSplicer Bank - WiringNextInline Fuse Holder - Wiring

Last updated