Wheel Coupler Assembly
This page describes how to assemble the motor wheel coupler, to be used when added the wheels to the motors.
Parts Needed
1
Insert four M4 nylon lock nuts into the hex cut-outs in the coupler body.
2
Align the small post on the Clamp body halves with the “U” shaped cut-out on the coupler body and slide the two C-Clamps together into the U-shape cut-outs.
3
Insert an M4 x 16mm screw along with an M4 nylon lock nut into the clamp body halves and loosely tighten using the 3mm drive hex L-key.
Do not tighten. screws should be very loose.
4
Repeat steps 1-3 for the remaining 3 motor wheel couplers.
Last updated