Junction Box to Frame Assembly

This page describes adding the junction box to the frame assembly

Completed junction box to frame assembly

Parts Needed

Instructions

1. Place the junction box lid on a flat surface upside down then place the junction box on its lid with the feet of the junction box facing up

Preparing the junction box for assembled frame

1. Flip the frame assembly upside down and place it on top of the junction box with each elbow mount tabs aligned with each of the four junction box feet

Aligning the elbow mount tabs with the junction box feet

1. Insert the Junction Box Feet screws through each of the frame assembly tabs and tighten using the Philips #3 screwdriver.

Inserting the junction box feet screws.