Motor Mount Assembly

This page describes how to assemble 4 motor plates to be used in the elbow mount assemblies.

Completed motor plate assemblies

---

Parts Needed

---

Instructions

1

Align the circular portion of the Motor Plateount with the raised circle on the motor (opposite the motor shaft). Ensure that the ribbed side of the Motor Plate is facing the motor.

Aligning the motor plate with the motor

2

Insert an M4 x 10mm screw into each of the 4 holes on the Motor Plate one at a time and tighten using the 3mm Drive Hex L-Key.

Inserting and tightening the M4 x 10mm screws

3

Repeat steps 1-2 for the remaining 3 motors.