Elbow Mount Assembly

This page describes how to assemble 4 elbow mount assemblies to be used in the frame assembly.

Completed elbow mount assemblies

---

Parts Needed

---

Instructions

1

Slide the plastic edges of the assembled motor plate fully into the grooves of the lower body elbow mount.

Motor plate assembled to lower elbow mount

2

Slide the upper body elbow mount on to the remaining exposed edges of the Assembled Motor Plate and leave it about half ways down as illustrated below.

Sliding upper body elbow mount on to assembled motor plate

3

Loosely add the M4 x16 mm screws along with the M4 nylon lock nuts to the elbow mount assembly by:

1. Inserting a Short Tube into the opening opposite the letter on the elbow mount assembly. Ensure that the holes on the tube are rotated away from the posts on the elbow mount assembly.

Short tube being temporarily inserted into elbow mount.

1. Press down the upper body elbow mount until its posts are pressed against the tube.

Short tube being temporarily inserted into elbow mount

1. Add an M4 x16mm screw along with an M4 nylon lock nut to each of the holes on the elbow mount assembly and tighten just enough to where the M4 nylon lock nut catches the M4 x16mm screw.

Inserting the M4 x16 screws and lock nuts loosely

4

Remove the short tube from the elbow mount assembly and repeat step 1-3 for the remaining 3 elbow mount assemblies.

Removing the short tube